● MANDATORY ISO 11088 NOTICE

Terms of Service & Disclaimer

Last Updated: September 30, 2026

1. Mandatory Ski Safety & Release Disclaimer

DIN Calculator Pro generates estimated ski binding release settings according to mathematical formulas and lookup tables published in the international standard ISO 11088:2023 (Assembly, adjustment and inspection of the ski-binding-boot system).

These calculations are provided strictly for educational, informational, and reference purposes only. Ski binding release mechanisms are life-safety devices designed to reduce the risk of lower leg fractures during certain types of falls. Bindings cannot prevent all injuries (such as knee ACL/MCL ruptures) and may not release in all crash scenarios.

2. Professional Workshop Calibration Required

Calculated numerical values on this website do not constitute professional equipment calibration or technical adjustment services. The safe operation of any ski binding system depends on numerous physical variables not measurable through a digital form, including heel and toe lug wear, boot sole compliance, binding forward pressure, and anti-friction device condition.

Heel and toe lug wear, contamination, and ISO 5355 / GripWalk sole compliance.
Binding forward pressure indicator alignment and screw torque.
Anti-friction device (AFD) mechanical condition and clearance.
Internal spring fatigue, corrosion, or mechanical degradation.

You must have your ski boots and bindings inspected, adjusted, and mechanical torque-tested on calibrated diagnostic test equipment by a certified ski technician prior to skiing.

3. Assumption of Risk & Inherent Danger

Snow skiing, snowboarding, and alpine touring are inherently hazardous recreational activities that carry unavoidable risks of severe physical trauma, catastrophic injury, paralysis, and death. By accessing this website, you acknowledge and agree that you voluntarily assume all risks associated with your participation in snow sports and the configuration of your equipment.

4. Disclaimer of Warranties ("As-Is")

DIN Calculator Pro is provided on an "as-is" and "as-available" basis without warranties of any kind, whether express, implied, statutory, or otherwise. We make no warranty that calculations will be error-free or uninterrupted.

5. Limitation of Liability

To the maximum extent permitted by applicable law, the authors, maintainers, and operators of dincalculatorpro.com shall not be liable for any direct, indirect, incidental, special, consequential, or punitive damages arising out of or related to your use of this application.

6. Intellectual Property, ISO Attribution & Copyright

"ISO" is a registered trademark of the International Organization for Standardization. DIN Calculator Pro is an independent, non-commercial web application not affiliated with or endorsed by ISO or DIN e.V. Table values are referenced under fair use.